Call Our Friendly Team Today On 01902 229412
Call Our Friendly Team Today On 01902 229412

How to Install Wave Tile Sheeting?

WAVE TILE 33/1000 tile sheeting can only be laid left to right, due to only being tiled one way. Making sure the overlapping edge is at the start of the process ready for the next sheet to overlap the underlapped side (as shown). We recommend laying away from the common prevailing wind to help prevent wind whistling and water capillary but on this profile sometimes this cannot be helped. Please note the overlapping edge is always the unfinished castle overlapping the finished castle.

Fixing screws are highly recommended to fix the strengthening ribs in the valley of the sheet (as shown). These are usually used in the 1st, 3rd and 5th trough (left, middle, right) to have a symmetrical appearance and a strong holding into the purlins. But as the drawing shows please try and fix in the flattest part of the trough to allow this fixing to sit tight against the purlin without kinking the sheet, as this profile has varying radius’. Fix in every purlin if possible but every two is adequate on short purlin spacings.

Wave Tile Installation
Image shown is for illustration purposes only

We recommend using a maximum purlin spacing of either 300mm or 600mm for 0.5mm only, due to the tile centres being at 300mm. Having an irregular purlin centre may result in a tile crimp sitting directly onto the purlin creating an uneven lay in the finished roof.

Stitching the sheeting overlaps are very important (as shown). Stitching the overlapping castle every 300mm (each tile) is adequate but if you can fix at 600mm (every 2 tiles) if necessary. This will help prevent water capillary seeping underneath the sheet. Applying lap tape isn’t recommended with this profile but silicone can be used if you require.

Ridge and Barge flashings are always fitted after the sheeting. Again, using the stitching screw to fix through the flashing into the castle of the sheeting. Once this process is complete then fitting a foam infill between the ridge end and the eaves end is recommended to help prevent birds / vermin entering the structure at the same time stopping wind pushing anything through during poor weather conditions. (Please note we DO NOT recommend using foam infills if you have our Drip stop membrane system installed to your sheeting due to the roof requiring ventilation for the Drip stop to work at its optimum).

If the sheeting or flashings need cutting / trimming, we recommend using a ‘Nibbler Attachment’ due to the clean precision cut it can offer. Angle grinders are commonly used but this will not offer a clean cut. A Nibbler will be the most sufficient tool for this.